Toyota : FJ CRUISER Suspension Options
Vehicle Information
Make : Toyota
Model : FJ CRUISER
|
Type : 4X4 IFS WAGON LWB
Sub Type : 2006-On
|
Front Suspension : Coil Spring
|
Rear Suspension : Coil Spring
|
Vehicle Details :
LBA "Load Bearing Accessories"
GVM "Gross Vehicle Mass"
|
|
Available Kits
| Kit Name |
Kit Price |
| UHK-TOY-008A "Aussie Ryder" |
$1,167.00 (ea kit) |
| UHK-TOY-008B + Pre-Assembled Struts |
$1,354.00 (ea kit) |
Kit Includes :
2xpr Coils Springs
2x Struts
2x Shock Absorbers
Hide Component Details
|
|
Front Suspension
Front Shock Absorber/Steering Damper Options
| Shock Absorbers |
Part Number |
Price |
| Aussie Ryder Twin Tube Gas Strut 0-50mm |
AR744150 |
$203.50 (ea) |
| Steering Dampers |
Part Number |
Price |
| NON Steering Damper Vehicle |
none |
P.O.A. (ea) |
|
Front Coil Spring Options
| Name |
Construction |
Price |
|
|
|
|
|
|
|
| TFR-118 |
Raised Height 0-50kg LBA 40-50mm |
$220.00 (pr) |
|
|
|
|
|
|
|
| TFR-118EHD |
Raised EHD 100-120kg LBA 40-50mm |
$220.00 (pr) |
|
|
|
|
|
|
|
| TFR-118HD |
Raised HD 50-100kg LBA 40-50mm |
$220.00 (pr) |
|
|
|
|
|
|
|
| TFS-118 |
Standard HD 0-50kg LBA 0-20mm |
$220.00 (pr) |
|
|
|
|
|
|
|
Front Suspension Notes
SUSPENSION BUSHES AND PARTS (NOT INCLUDED IN UHK-TOY-008A)
HIL-PREASSY "Pre-Assembled Struts (Uses TOPHAT-1083)" ..............1x $187.00
<<< OR >>>
TOPHAT-1083 "Strut Tops (includes new top bushes)" .........................2x $93.50 each
(NOT INCLUDED IN COMPLETE KITS)
ARB144140BT "Bottom Strut Bush (SUITS ULTIMATE STRUTS ONLY)" 2x $36.30 each
CASTOR/CAMBER CORRECTION
With some vehicles, a perfect wheel alignment cannot be achieved with a raised height suspension kit. It may be necessary to install eccentric control arm bushes to correct the alignment. A wheel alignment should be carried out to calculate if castor correction bushes are required.
SPF3230K "Upper Control Arm Bush Kit- Front Inner Eccentric" $320.00
Note: Vehicles require wheel alignment, headlight and brake proportioning valve adjustment with raised suspension.
All raised height measurements are listed as a guide only.
|
|
Rear Suspension
Rear Shock Absorber Options
| Shock Absorbers |
Part Number |
Price |
| Aussie Ryder Twin Tube Gas 0-50mm |
AR744151 |
$160.00 (ea) |
|
Rear Coil Spring Options
| Name |
Construction |
Price |
|
|
|
|
|
|
|
| TRR-119 |
Raised Height Loads to GVM 40-50mm |
$220.00 (pr) |
|
|
|
|
|
|
|
| TRR-119HD |
Raised HD 150kg to GVM 50mm |
$220.00 (pr) |
|
|
|
|
|
|
|
| TRS-119 |
Standard HD Loads to GVM 0-20mm |
$220.00 (pr) |
|
|
|
|
|
|
|
Rear Suspension Notes
OPTIONAL
FIRESTONE AIRBAG KITS
CR5013 ....."Coil Rite Standard Height- Light Loads" ......$299.00
CR5013HP "Coil Rite Standard Height- High Pressure" ...$375.00
CR5034 ....."Coil Rite 2� Lift- Light Loads" ......................$299.00
CR5034HP "Coil Rite 2� Lift- High Pressure" ...................$375.00
NOTE: Compressors and On Board Air Kits are also available
Recommend Suspension Service every 12 months or 20,000km.
|
|
Special Information
- Vehicle heights may vary due to load and accessorie requirments, as a general rule a Standard Height Heavy Duty spring will raise the vehicle approx. 30mm while a Raised Height Comfort or Heavy Duty spring will raise the vehicle approx. 50mm (On a new vehicle with standard height)
- WHEEL ALIGNMENT REQUIRED
- MANDATORY 1,000KM CHECK-UP AND RE-TIGHTEN (Required under warranty conditions)
- All prices quoted are in Australian dollars, inclusive of GST. Fowarding, freight and fitting not included.
- CAUTION: Due to transort regulation in Australia, any increase in vehicle height greater than 50mm will require an engineers certificate. Check compliance with state transport Authorities
|
|
Back to the Toyota List
|
|
The Ultimate Suspension
2 Noonan Road
Ingleburn NSW 2565
Ph: 02 9618 7674
Int: +612 9618 7674
Fax: 02 9603 7249
|
|
